hey there
i couldnt post on wireless section so here it goes :

i'm using a proxim based wifi card which is recognized by BT2 very well
i need to use monitor mode to relay all air traffic to IDS , but i couldnt manage to bridge the wireless interface , or even route the traffic from wifi interface in monitor mode to one of ethernet interfaces which is connected to analyzer , help me out please

btw , i am not sure that i am in a "right" monitoring situation , because i cannot grab traffix from tcpdump -i wifi0 or tcpdump -i ath0 etc etc , i can only run kismet then its virtual interfaces named "kis" streams all the traffic : tcpdump -i kis
so let me know what should i do for a proper monitoring situation , and bear with me if i am not that much advanced

best regards