SOLVED!!: http://f&#111 ;rums.rem&# 111;te-expl&#111 ;it.org/s&#1 04;owthread .php?t=10& #57;85&highl& #105;ght=ath&#101 ;ros+conn&#1 01;ction

same issue :

hxxp://forums.remote-exploit.org/showpost.php?p=43351&postcount=10
* i tried dhclient times out too
* if I use airmon to set the channel I get perm denied from iwconfig when I try to set the essid


Code:
# SSID is set right 

bt stuff # iwconfig wlan0
wlan0     802.11b/g  ESSID:"ags_guest"
          Mode:Managed  Channel=4  Access Point: Not-Associated
          Bit Rate=11 Mb/s   Tx-Power=5 dBm
          Retry:on   Fragment thr:off
          Encryption key:off
          Link Quality=0/100  Signal level=-178 dBm  Noise level=-156 dBm
          Rx invalid nwid:0  Rx invalid crypt:0  Rx invalid frag:0
          Tx excessive retries:0  Invalid misc:0   Missed beacon:0


bt stuff # airmon-ng start wlan0 1


Interface       Chipset         Driver

wifi0           Atheros         madwifi-ng
wlan0           RTL8187         r8187 (monitor mode enabled)



# then i lose the ssid that is set ..  

bt stuff # iwconfig wlan0
wlan0     802.11b/g  Mode:Monitor  Channel=1  Bit Rate=11 Mb/s
          Tx-Power=5 dBm
          Retry:on   Fragment thr:off
          Link Quality:79/100  Signal level:-215 dBm  Noise level:-235 dBm
          Rx invalid nwid:0  Rx invalid crypt:0  Rx invalid frag:0
          Tx excessive retries:0  Invalid misc:0   Missed beacon:0


# try to set it back ...

bt stuff # iwconfig wlan0 essid 'ags_guest'
Error for wireless request "Set ESSID" (8B1A) :
    SET failed on device wlan0 ; Operation not permitted.
using wlan0 RTL8187 r8187

how do I connect I know DHCP works using ATH0 ( on board ) when I use

iwassistant I get errors when it sets the channel so not sure what I am missing..

if I disable the onboard and boot iwassistant gives the same error

"