Hi,

Hope this is in the right section, I've recently installed BT3 onto my hard drive

when testing wep or wpa, I get the below issues, in this case it's WPA

when I type
aireplay-ng -0 1 -e ESSID -a router -c station ath0
I get below, i press up key to retype the same command some times this can take about
6 times & it will eventually Send DeAuth to station, but 1/5 times it will give handshake,
the rest of the times it will disconnect my other laptop that's physically connected & either give limited
or no connectivity, or it will auto reconnect, but the time that it takes to reconnect, I dont get handshake
Does my card need to be set on a channel to match the AP, is there a way around this, as i've never
experienced issues with BT2, & also that was just running from a live cd, cheers for looking guys

11:22:00 ath0 is on channel 7, but the AP uses channel 1
bt ~ # aireplay-ng -0 1 -e ESSID -a router -c station ath0
11:22:01 Waiting for beacon frame (BSSID: router) on channel 4
11:22:03 ath0 is on channel 4, but the AP uses channel 1
bt ~ # aireplay-ng -0 1 -e ESSID -a router -c station ath0
11:22:58 Waiting for beacon frame (BSSID: router) on channel 1
11:22:59 Sending DeAuth to station -- STMAC: [station]