Hi

I got my ALFA Wireless USB stick today!! + a 2dBi antenna
But none of the attacks are working properly.

I'm running BT3 on VMware, i also tried live CD BT2 and BT3 but gave same results.

Seems to be recognized by BT3 on insert / boot:

Code:
usb 1-1: new high speed USB device using ehci_hcd and address 3
usb 1-1: configuration #1 chosen from 1 choice
rtl8187: Enabling 14 channels.
rtl8187: MAC chip version: 04
rtl8187: Card type: AD
rtl8187: Reported EEPROM chip is a 93c46 (1Kbit) 
rtl8187: Card MAC address is 00:c0:ca:19:e1:11
rtl8187: RF Chip ID: 05
rtl8187: Card reports RF frontend Realtek 8225
rtl8187: WW:This driver has EXPERIMENTAL support for this chipset.
rtl8187: WW:use it with care and at your own risk and 
rtl8187: WW:**PLEASE** REPORT SUCCESS/INSUCCESS TO andreamrl@tiscali.it
rtl8187: This seems a new V2 radio
rtl8187: PAPE from CONFIG2: 0
rtl8187: Driver probe completed
Seems good, ok lets run some tests.

Code:
iwlist wlan0 bitrate
Current Bit Rate=11 Mb/s
So that's good, nextup iwconfig:

Code:
wlan0     Link encap:Ethernet  HWaddr 00:**:**:**:**:11 (you get the idea)
          inet addr:192.168.1.108  Bcast:192.168.1.255  Mask:255.255.255.0 
          UP BROADCAST NOTRAILERS RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:690 errors:0 dropped:7220 overruns:0 frame:0
          TX packets:645 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000 
          RX bytes:460993 (450.1 KiB)  TX bytes:235129 (229.6 KiB)
So i am able to connect to a secure WEP router.
So lets disconnect from that router and try to hack it.

So lets bring everything down:
Code:
ifconfig wlan0 down
airmon-ng stop wlan0 down

Interface          Chipset          Driver
wlan0              RTL8187         r8187 (monitor mode disabled)
Ok, next i'm booting everything up.

Code:
airmon-ng start wlan0 4 (my router channel)
//Outputs same as above only (monitor mode enabled)

ifconfig wlan0 up
Now everythings seems to work.
I use airodump-ng on channel 4, and the bssid from my router, and it shows up perfectly and all connected stations.

Now with all attacks most attacks start, and displaying normal.
But when its start sending packets, the data wont go up...

I tryed command, if you would like to view the outcome of a command please post wich attack Because the topic has text limit.

If somebody could help me, i would really appreciate it.
I thought buying this card would solve the problems i had with ipw3945.
But it looks almost the same

Thanks again for anyone who can help me out!