Results 1 to 2 of 2

Thread: lilo configuration

  1. #1
    Junior Member
    Join Date
    Nov 2007
    Posts
    36

    Default lilo configuration

    I thought I would post this in case it can be useful to another newb.

    I recently used QTParted to add some physical space on my drive to install BT3.

    After successfully installing BT3, I realized lilo (boot loader) was not recognizing my original Vista partition. I only had the option to boot into BT3.

    The following is what I did to fix it.

    At the terminal type: kwrite \etc\lilo.conf


    boot = /dev/sda
    prompt
    timeout = 60
    #bitmap=/boot/splash.bmp
    change-rules
    reset
    #vga = 769,771/773/792
    vga = 769
    image = /boot/vmlinuz
    root = current
    label = BackTrack
    read-only


    and add the following line at the end

    other= /dev/sda2
    label = Windows Vista


    Save the lilo.conf

    In a terminal window type: lilo

    It should rebuild with your new config. When you restart you should see the option to boot into both OS's.

    Hope this helps!

  2. #2
    Member
    Join Date
    Dec 2007
    Location
    @InterN0T
    Posts
    315

    Default

    That should work ^^ write lilo -v to be verbose so you can see if there was any problems.
    ( i might do it a little different sometimes though)
    [quote][I]I realized, that I had fallen down from the top of the mountain into a deep, terrifying and dark hole, just to find out that another mountain in front of me, much greater than the previous, was the next step in life. I began to wander uphill on the next mountain of life while I knew it would be much harder than the previous mountain. [/I]- MaXe[/quote]

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •