Hi Sirano! Can u post few steps how did u setup drivers. I installed drivers from official tp link site for win7, works great in win and in bt. but when i try to scan airodump-ng wlan0 i got this
ARP linktype is set to 1 (Ethernet) - expected ARPHRD_IEEE80211,
ARPHRD_IEEE80211_FULL or ARPHRD_IEEE80211_PRISM instead. Make
sure RFMON is enabled: run 'airmon-ng start wlan0 <#>'
Sysfs injection support was not found either.
And yeah i tried to run airmon-ng start wlan0, just turned on mon0 mode, and still not working. I understand that i need drivers supported by bt and i tried few method's but non of them worked.
And yeah my chipset is kinda weird:
Interface Chipset Driver
wlan0 AR9001/9002/9271 usb - [phy0]
it look like i have 3 drivers installed but i dont. I can see ARP i set to 1 and need to be set on 11, duuno if that is what i need to do.
and yeah my lsusb:
Bus 002 Device 003: ID 0e0f:0002 VMware, Inc. Virtual USB Hub
Bus 002 Device 002: ID 0e0f:0003 VMware, Inc. Virtual Mouse
Bus 002 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub
Bus 001 Device 002: ID 0cf3:1006 Atheros Communications, Inc.
Bus 001 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub
Thx in advance!