AWUS 036 NHR problem driver install

[maverik35]

Make sure you have installed the linux headers and build-essential.

Then to avoid the Warning: "Symbol version dump /usr/src/linux-source-3.2.6/Module.symvers is missing; modules will have no dependencies and modversions." you need to make a link pointing to the Module.symvers.

Why?..Because the file needed to build driver is at /usr/src/linux-headers-3.2.6/Module.symvers and when compiling, it enters to /usr/src/linux-source-3.2.6 looking for that file, but it is not there, so we create a link pointing to that module:

ln -s /usr/src/linux-headers-3.2.6/Module.symvers /usr/src/linux-source-3.2.6/Module.symvers

Then, try to install again..Please post in case of any error.

Listen, there are 2 other ways to install it: compat-drivers and firmware-realtek (0.36+wheezy.1) just in case the one you are trying with is not succsefull..

[osuperbuy]

I have 2 wep wey from 2 AP
I 'v tryed to conect and i can't because receive msg " bad pasword"
with same wep key or wpa with wifi card of laptop i have no problem
I must do another things :

Verry bad when are " small" or " dust " in domain

thank you bro for your patience
i gues i will use my hammer for forget this adaptor with a lot of problem ( for me )

I will edit a little bit my last post:

For a short time my machine has worked with adaptor -i see networks around and i can conect to one network
after cmd : iwconfig i see in terminal for first time ESSID: REALTEK ********** , but after first reboot all gone.
During to my conection with adaptor led of adaptor blinking -working ,now is freezy just lightening and no blinking .
If i change Wlan0 in Wlan2 all networks gone( Wlan2 is my adaptor),i see nothing.
if i have cmd : modprobe 8192cu i have error: FATAL: Error inserting 8192cu (/lib/modules/3.2.6/kernel/drivers/net/wireless/8192cu.ko): Device or resource busy

[osuperbuy]

yesterday for 1 moment i think i have solve my problem : after again on trying to instal drivers and reboot .I see my adaptor and i have worked with this .But again after reboot when i check with iwconfig

i have this:

root@bt:~# iwconfig
wlan2 IEEE 802.11bgn ESSIDff/any ( when my adaptor was ok and working here after ESSID i see writ somethimg like : REALTEK ..... , and now is like you see off/any. And led of adaptor blinking ,now if i change from WICD wlan0 with wlan2-my adaptor ,just led is up)
Mode:Managed Access Point: Not-Associated Tx-Power=0 dBm
.................................................. .................................................. .................................................. ........................
So for 1 moment i think i have solved my problem ,but was just one dream.I think i must do something ++ .

[osuperbuy]

Ufffffffffffffff

No1 give me one answer or for guide me to a good way?!
So i will write again all seps folowed:
Open 2 terminals:

download from here drivers
Modify inside of files and put inside to archive directory with files modified
after i open 1-st terminal where i prepare kernel
second step open second terminal where i go where i have drivers and put command for install
nothing happened
all are like before
If i try to change Wlan0 in Wlan1 i can but if i refresh i see nothing , no wifi network...
For first time with 2 days ago my adaptor work well ( led blinking and conection with wifi network was done verry fast
).