probleme with airmon-ng and my network card

[omar254]

hi,
im new here and also new with Backtrack,but after lot of efforts to get connected in wifi,i found another probleme,
in the terminal this is what i get:

root@bt:~# airmon-ng


Interface	Chipset		Driver

eth1		Broadcom		wl

root@bt:~# airmon-ng start eth1


Found 3 processes that could cause trouble.
If airodump-ng, aireplay-ng or airtun-ng stops working after
a short period of time, you may want to kill (some of) them!

PID	Name
768	NetworkManager
906	wpa_supplicant
1246	dhclient
Process with PID 1246 (dhclient) is running on interface eth1


Interface	Chipset		Driver

eth1		Broadcom		wl (monitor mode enabled)

is this normal or i should get something else here wl (monitor mode enabled)?
like wl (monitor mode enabled on ...)?
my configuration is:
backtrack 5 R3 32 bits
Laptop:Hp Pavilion G 6
wireless card:Broadcom 4312.
Kernel Linux : 3.2.6
thanks for your help.

[Jimmy87]

I have a Dell Inspiron 1525 which has the Broadcom 4312 chip. If I boot from a BT5 (not r3) it loads the driver "b43" version 2.6.38 and it works perfectly.

[daedalus1776]

eth1 is usually ethernet

[Jimmy87]

eth1 is usually ethernet

But from his output after running the airmon-ng command it reports the interface as eth1 which should be fine. More likely to be a chipset/driver combination I think. Further more to my last post, I *think* I remember seeing that the chipset was 14e4:4315 (rev01) in the Dell laptop.

OP can you post the details of your wireless card?