Trouble with intel 5300

[DoubelR]

Hello I seem to be having some trouble injecting packets with my intel 5300. I was wondering if I have the wrong driver or firmware, any help would be greatly appreciated.

-RR

root@bt:~# airmon-ng start wlan0


Found 3 processes that could cause trouble.
If airodump-ng, aireplay-ng or airtun-ng stops working after
a short period of time, you may want to kill (some of) them!

PID Name
1496 dhclient3
1497 dhclient3
10885 dhclient
Process with PID 1497 (dhclient3) is running on interface wlan0


Interface Chipset Driver

wlan0 Intel 5300AGN iwlwifi - [phy0]
(monitor mode enabled on mon0)

root@bt:~# aireplay-ng -9 wlan0
18:45:57 Trying broadcast probe requests...
18:45:59 No Answer...
18:45:59 Found 1 AP

18:45:59 Trying directed probe requests...
18:45:59 XX:XX:XX:XX:XX:XX - channel: 161 - '5G'
18:46:05 0/30: 0%



description: Wireless interface
product: Ultimate N WiFi Link 5300
vendor: Intel Corporation
physical id: 0
bus info: pci@0000:0c:00.0
logical name: mon0
version: 00
serial: 00:21:6a:69:ef:8c
width: 64 bits
clock: 33MHz
capabilities: pm msi pciexpress bus_master cap_list logical wireless ethernet physical
configuration: broadcast=yes driver=iwlwifi driverversion=3.2.6 firmware=8.83.5.1 build 33692 ip=192.168.1.9 latency=0 link=yes multicast=yes wireless=IEEE 802.11abgn
resources: irq:45 memory:f69fe000-f69fffff

[Sou11ow]

You can kill the processes with "kill **** = PID number"

I should be able to check your drivers with a bit of googling, but this may help . http://wireless.kernel.org/en/users/Download

And you can run an injection test to see if it is working following aircracks direction http://www.aircrack-ng.org/doku.php?id=injection_test


An additional feature is the ability to test connectivity to airserv-ng. Once the basic connectivity test is completed then it proceeds with the standard injection tests via the wireless card linked to airserv-ng.

Usage

aireplay-ng -9 -e teddy -a 00:de:ad:ca:fe:00 -i wlan1 wlan0

Where:

-9 means injection test. Long form is --test.
-e teddy is the network name (SSID). This is optional.
-a 00:de:ad:ca:fe:00 ath0 is MAC address of the access point (BSSID). This is optional.
-i wlan1 is interface name of the second card if you want to determine which attacks your card supports. This interfaces acts as an AP and receives packets. This is optional.
wlan0 is the interface name or airserv-ng IP Address plus port number. This interface is used to send packets. For example - 127.0.0.1:666. (Mandatory)

Hope this helps.