wicd/ip problems

[DimitriDV]

Hey guys,

i have problems obtaining a IP adress when i connect to a AP with wicd, it just say "Connection Failed: Unable to Get IP Address"

Its also something strange with the ESSID name on iwconfig after I tried to connect. Not sure its related but most probably. To me it just seem like random jibberish.

The picture is taken after i tried to connect with wicd and failed then reconnected with networkmanager (which works).

wlan0 is the internal BC wifi.
wlan1 is a atheros USB.

But it effects both.

The AP is a open, non secure.

Not sure what other info i should post, let me know if you need something more and I will try to look it up.
Thnx

DSC_0018.jpg

[maverik35]

For the info in the pic, the wlan1, the AP or PC location is way way far. The link quality (very important parameter) is 29/70 (Little over 40% of signal Rx) and -80db..That is very poor to even get associated....Again, either it is a lot of obstruction in between the AP and PC or is far away..

It wouldn't suprise me if you do not even get an IP at wlan1 or wlan0..Need to get a better signal and then try to associate again and get a valid IP...

The strange ESSID name, I had many times that problem and it was due to not being able to get the right info from AP beacons...A lot of signal degradation due to blocking issues, interference issues (noise), distance, etc...

Try to get closer at least to get a -65 dbi and Link quality over 80% (58/70 or more) and see what happens.

Luck

[smlaid]

Hi all
If Wicd is giving you hell, follow this tutorial !

http://www.backtrack-linux.org/forum...ad.php?t=49238