This is a new install of Backtrack 5.3 with nmap 6.01. From what I've read in these forums and on Google, this problem is being caused by monitor mode. My question is how to I end monitor mode, but keep connected to my network?

-The error happens on both eth0 and wlan0 interfaces.
-nmap starts to work, if I use the --unprivileged switch, but then complains that it can't run most scans that way.
-when I use 'airmon-ng stop wlan0' it shows "monitor mode disabled", but then I'm disconnected from my network.

So suggestions about how to get nmap started would be appreciated. This is most likely a user problem.