wicd can not find access point for wifi

[bekir]

hello,

I configure my internet connection using the videos found on Offensive security, but when I run it wicd can not find access point for wifi....
I give you some information on the computer :
lspci :
00:00.0 Host bridge: Intel Corporation Mobile 4 Series Chipset Memory Controller
Hub (rev 07)
00:02.0 VGA compatible controller: Intel Corporation Mobile 4 Series Chipset Int
egrated Graphics Controller (rev 07)
00:02.1 Display controller: Intel Corporation Mobile 4 Series Chipset Integrated
Graphics Controller (rev 07)
00:1a.0 USB Controller: Intel Corporation 82801I (ICH9 Family) USB UHCI Controll
er #4 (rev 03)
00:1a.1 USB Controller: Intel Corporation 82801I (ICH9 Family) USB UHCI Controll
er #5 (rev 03)
00:1a.7 USB Controller: Intel Corporation 82801I (ICH9 Family) USB2 EHCI Control
ler #2 (rev 03)
00:1b.0 Audio device: Intel Corporation 82801I (ICH9 Family) HD Audio Controller
(rev 03)
00:1c.0 PCI bridge: Intel Corporation 82801I (ICH9 Family) PCI Express Port 1 (r ev 03)
00:1c.1 PCI bridge: Intel Corporation 82801I (ICH9 Family) PCI Express Port 2 (r ev 03)
00:1d.0 USB Controller: Intel Corporation 82801I (ICH9 Family) USB UHCI Controll er #1 (rev 03)
00:1d.1 USB Controller: Intel Corporation 82801I (ICH9 Family) USB UHCI Controll er #2 (rev 03)
00:1d.2 USB Controller: Intel Corporation 82801I (ICH9 Family) USB UHCI Controll er #3 (rev 03)
00:1d.3 USB Controller: Intel Corporation 82801I (ICH9 Family) USB UHCI Controll er #6 (rev 03)
00:1d.7 USB Controller: Intel Corporation 82801I (ICH9 Family) USB2 EHCI Control ler #1 (rev 03)
00:1e.0 PCI bridge: Intel Corporation 82801 Mobile PCI Bridge (rev 93)
00:1f.0 ISA bridge: Intel Corporation ICH9M-E LPC Interface Controller (rev 03)
00:1f.2 SATA controller: Intel Corporation ICH9M/M-E SATA AHCI Controller (rev 0 3)
00:1f.3 SMBus: Intel Corporation 82801I (ICH9 Family) SMBus Controller (rev 03)
00:1f.6 Signal processing controller: Intel Corporation 82801I (ICH9 Family) The rmal Subsystem (rev 03)
01:00.0 Ethernet controller: Attansic Technology Corp. Device 1063 (rev c0)
02:00.0 Network controller: Intel Corporation WiFi Link 1000 Series
Edit/Delete Message

root@bt:~# iwconfig
lo no wireless extensions.

eth0 no wireless extensions.

wmaster0 no wireless extensions.

wlan0 IEEE 802.11bgn ESSID:""
Mode:Managed Frequency:2.412 GHz Access Point: Not-Associated
Tx-Power=0 dBm
Retry min limit:7 RTS thr:Off Fragment thr:0ff
Encryption key:0ff
Power Management:Off
Link Quality:0 Signal level:0 Noise level:0
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0

[xX_Spiidey_Xx]

Did you start networking?

/etc/init.d/networking start

Even with my borked Ninty WiFi USB connector passed through to my VM running BT4 live allows me to connect to my AP using WPA supplicant after starting networking.

[Bud Jones]

try typing:

iwlist scanning

[bekir]

quand j'�cris /etc/init.d/networking start i have this :

root@bt:~# /etc/init.d/networking start
Configuring network interfaces...eth1: ERROR while getting interface flags: No such device
Internet Systems Consortium DHCP Client V3.1.1
Copyright 2004-2008 Internet Systems Consortium.
All rights reserved.
For info, please visit http://www.isc.org/sw/dhcp/

SIOCSIFADDR: No such device
eth1: ERROR while getting interface flags: No such device
eth1: ERROR while getting interface flags: No such device
Bind socket to interface: No such device
Failed to bring up eth1.
eth2: ERROR while getting interface flags: No such device
Internet Systems Consortium DHCP Client V3.1.1
Copyright 2004-2008 Internet Systems Consortium.
All rights reserved.
For info, please visit http://www.isc.org/sw/dhcp/

SIOCSIFADDR: No such device
eth2: ERROR while getting interface flags: No such device
eth2: ERROR while getting interface flags: No such device
Bind socket to interface: No such device
Failed to bring up eth2.
ath0: ERROR while getting interface flags: No such device
Internet Systems Consortium DHCP Client V3.1.1
Copyright 2004-2008 Internet Systems Consortium.
All rights reserved.
For info, please visit http://www.isc.org/sw/dhcp/

when i start wicd i have this message NO WIRELESS NETWORKS FOUND

when I write iwlist wlan0 scanning i have this Interface doesn't support scanning : network is down and when i write ifconfig wlan0 up i have this wlan0 : error while getting interface flags : no such device

[tehgame]

i seem to have a similar problem:

http://www.backtrack-linux.org/forum...dden-ssid.html

EDIT: i guess i found out what the reason is, but have no solution.

[bekir]

I burn pentoo on CD and I tried wicd with it and it works, Is there someone who can explain...

[tehgame]

in the link to my thread i mentioned it seems to have something to do with the lack of the intel wifi link 1000 series ucode file in connection with iwlagn driver.

ubuntu 9.10 works just fine for me, too.

devs, pls make a solution. i want to try bt4.