I run the process like this:
terminal 1: wpa_supplicant -Dwext -iwlan0 -c/etc/wpa_supplicant.conf –B
terminal 2: wpa_cli - then: status, then add it the bssid and the pin
terminal 3: dhclient wlan0
then open firefox and got internet connection - went to whatismyip.org and got outside-external ip number
#cat /etc/wpa_supplicant.conf - gives me psk on the wpa_supplicant at root/etc, file set earlier
Now the same PSK did not work on Wicd it keep telling me that is a "Bad Passwork"
if I put the pin number as a password or the PSK, nothing - same in windows
Now, I know I can connect to the AP in BT5-R2 linux but using this 3 command on 3 different terninal...
I close the terminal for wpa_cli...still connected
My question is, how can I use it in Windows?
I have never try it via cmd in windows
Boot off and try the same procees
It did not work at first, since I am running BT5 R2 and reaver 1.4 on VMware, poweroff of BT5 R2 and shut down windows
then it work again, but only in BackTrack
It drives you nuts, that you can connect to the AP using the above, but you still can not get the correct PSK