hello guyz,

i have a problem starting kismet. who can help me..
I have :
- hd install backtrackfinal
- updated aircrack etc from livecd to 0.9. via the svn
- updated rt61 to newer version, before I saw ra0 after update I see wlan0

here is some output, if you need more , I can suply ofcourse.

What I read in different treats is that I have to update my kismet.conf, but what should I give source=?????? how can I check that ?

REGARDS DURANA


------------------------------




lo no wireless extensions.

wlan0 RT61 Wireless ESSID:"" Nickname:""
Mode:Managed Frequency:2.412 GHz Bit Rate=54 Mb/s
RTS thrff Fragment thrff
Encryption keyff
Link Quality=0/100 Signal level:-121 dBm Noise level:-111 dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0

eth0 no wireless extensions.

bt ~ # ifconfig
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)


bt ~ # ifconfig wlan0 up
bt ~ # ifconfig
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)

wlan0 Link encap:Ethernet HWaddr 00:133:85:69:17
inet6 addr: fe80::213:d3ff:fe85:6917/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:32 errors:0 dropped:0 overruns:0 frame:0
TX packets:63 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:3566 (3.4 KiB) TX bytes:0 (0.0 b)
Interrupt:11
---------------------------------------------------------------------
bt ~ # kismet
Server options: none
Client options: none
Starting server...
Waiting for server to start before starting UI...
Suid priv-dropping disabled. This may not be secure.
No specific sources given to be enabled, all will be enabled.
Enabling channel hopping.
Enabling channel splitting.
FATAL: No packsources were enabled. Make sure that if you use an enablesource line that you specify the correct sources.
bt ~ #