Problems starting the wireless network card in monitor mode, dell inspiron n4110
Backtrack 5 KDE, Hard disk installed
I have problems starting the wireless network card in monitor mode, dell inspiron laptop n4110.
I'm buy a usb wireless network card D-Link DWA-125, this card use the Ralink RT3070 chipset, i'm have installed Backtrack 5 distribution, and I could not fully execute some scripts. (airmon-ng related)
This is the output of some commands that I executed:
The problems:Code:root@bt:~# ifconfig -a eth0 Link encap:Ethernet HWaddr xx:xx:xx:xx:xx:xx UP BROADCAST MULTICAST MTU:1500 Metric:1 RX packets:0 errors:0 dropped:0 overruns:0 frame:0 TX packets:0 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:1000 RX bytes:0 (0.0 B) TX bytes:0 (0.0 B) Interrupt:41 Base address:0x2000 lo Link encap:Local Loopback inet addr:127.0.0.1 Mask:255.0.0.0 inet6 addr: ::1/128 Scope:Host UP LOOPBACK RUNNING MTU:16436 Metric:1 RX packets:149 errors:0 dropped:0 overruns:0 frame:0 TX packets:149 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:0 RX bytes:10433 (10.4 KB) TX bytes:10433 (10.4 KB) wlan0 Link encap:Ethernet HWaddr xx:xx:xx:xx:xx:xx inet addr:192.168.0.3 Bcast:192.168.0.255 Mask:255.255.255.0 inet6 addr: xxxx::xxxx:xxxx:xxxx:xxxx/xx Scope:Link UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 RX packets:16856 errors:0 dropped:0 overruns:0 frame:0 TX packets:11146 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:1000 RX bytes:15418809 (15.4 MB) TX bytes:1627686 (1.6 MB) wlan1 Link encap:Ethernet HWaddr xx:xx:xx:xx:xx:xx UP BROADCAST MULTICAST MTU:1500 Metric:1 RX packets:0 errors:0 dropped:0 overruns:0 frame:0 TX packets:0 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:1000 RX bytes:0 (0.0 B) TX bytes:0 (0.0 B) root@bt:~# iwlist wlan1 scan wlan1 Scan completed : Cell 01 - Address: xx:xx:xx:xx:xx:xx Channel:2 Frequency:2.417 GHz (Channel 2) Quality=70/70 Signal level=-39 dBm Encryption key:on ESSID:"Hack-Lab" Bit Rates:1 Mb/s; 2 Mb/s; 5.5 Mb/s; 6 Mb/s; 9 Mb/s 11 Mb/s; 12 Mb/s; 18 Mb/s Bit Rates:24 Mb/s; 36 Mb/s; 48 Mb/s; 54 Mb/s Mode:Master Extra:tsf=00000001b5d24f4a Extra: Last beacon: 820ms ago IE: Unknown: 00084861636B2D4C6162 IE: Unknown: 010882848B0C12961824 IE: Unknown: 030102 IE: Unknown: 0706555320010B1B IE: Unknown: 200100 IE: IEEE 802.11i/WPA2 Version 1 Group Cipher : TKIP Pairwise Ciphers (2) : CCMP TKIP Authentication Suites (1) : PSK IE: WPA Version 1 Group Cipher : TKIP Pairwise Ciphers (2) : CCMP TKIP Authentication Suites (1) : PSK IE: Unknown: 2A0100 IE: Unknown: 32043048606C IE: Unknown: DD180050F2020101020003A4000027A4000042435E0062322F00 IE: Unknown: DD0900037F01010020FF7F Cell 02 - Address: xx:xx:xx:xx:xx:xx Channel:1 Frequency:2.412 GHz (Channel 1) Quality=21/70 Signal level=-89 dBm Encryption key:on ESSID:"Allison" Bit Rates:1 Mb/s; 2 Mb/s; 5.5 Mb/s; 11 Mb/s; 9 Mb/s 18 Mb/s; 36 Mb/s; 54 Mb/s Bit Rates:6 Mb/s; 12 Mb/s; 24 Mb/s; 48 Mb/s Mode:Master Extra:tsf=00000073f494c9b3 Extra: Last beacon: 1130ms ago IE: Unknown: 0007416C6C69736F6E IE: Unknown: 010882848B961224486C IE: Unknown: 030101 IE: Unknown: 32040C183060 IE: Unknown: 0706444520010D10 IE: Unknown: 050400010000 IE: Unknown: 2A0104 IE: WPA Version 1 Group Cipher : TKIP Pairwise Ciphers (2) : TKIP CCMP Authentication Suites (1) : PSK IE: IEEE 802.11i/WPA2 Version 1 Group Cipher : TKIP Pairwise Ciphers (2) : TKIP CCMP Authentication Suites (1) : PSK IE: Unknown: DD07000C4300000000 root@bt:~# lshw -C network *-network description: Wireless interface product: Centrino Wireless-N 1030 vendor: Intel Corporation physical id: 0 bus info: pci@0000:01:00.0 logical name: wlan0 version: 34 serial: xx:xx:xx:xx:xx:xx width: 64 bits clock: 33MHz capabilities: pm msi pciexpress bus_master cap_list ethernet physical wireless configuration: broadcast=yes driver=iwlagn driverversion=2.6.39.4 firmware=17.168.5.1 build 33993 ip=192.168.0.3 latency=0 link=yes multicast=yes wireless=IEEE 802.11bgn resources: irq:48 memory:d1600000-d1601fff *-network description: Ethernet interface product: RTL8101E/RTL8102E PCI Express Fast Ethernet controller vendor: Realtek Semiconductor Co., Ltd. physical id: 0 bus info: pci@0000:03:00.0 logical name: eth0 version: 05 serial: xx:xx:xx:xx:xx:xx size: 10MB/s capacity: 100MB/s width: 64 bits clock: 33MHz capabilities: pm msi pciexpress msix vpd bus_master cap_list ethernet physical tp mii 10bt 10bt-fd 100bt 100bt-fd autonegotiation configuration: autonegotiation=on broadcast=yes driver=r8169 driverversion=2.3LK-NAPI duplex=half latency=0 link=no multicast=yes port=MII speed=10MB/s resources: irq:41 ioport:3000(size=256) memory:d0404000-d0404fff memory:d0400000-d0403fff *-network description: Wireless interface physical id: 2 bus info: usb@2:1.3 logical name: wlan1 serial: xx:xx:xx:xx:xx:xx capabilities: ethernet physical wireless configuration: broadcast=yes driver=rt2800usb driverversion=2.6.39.4 firmware=0.29 link=no multicast=yes wireless=IEEE 802.11bgn root@bt:~# lsusb Bus 004 Device 001: ID 1d6b:0003 Linux Foundation 3.0 root hub Bus 003 Device 003: ID 0458:003a KYE Systems Corp. (Mouse Systems) NetScroll+ Mini Traveler / Genius NetScroll 120 Bus 003 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub Bus 002 Device 004: ID 07d1:3c16 D-Link System DWA-125 Wireless N 150 Adapter(rev.A2) [Ralink RT3070] Bus 002 Device 003: ID 8086:0189 Intel Corp. Bus 002 Device 002: ID 8087:0024 Intel Corp. Integrated Rate Matching Hub Bus 002 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub Bus 001 Device 004: ID 1bcf:2881 Sunplus Innovation Technology Inc. Bus 001 Device 002: ID 8087:0024 Intel Corp. Integrated Rate Matching Hub Bus 001 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub root@bt:~# lsmod | grep rt rt2800usb 12228 0 rt2800lib 40789 1 rt2800usb crc_ccitt 1581 1 rt2800lib rt2x00usb 10496 1 rt2800usb rt2x00lib 37138 3 rt2800usb,rt2800lib,rt2x00usb mac80211 277511 4 rt2800lib,rt2x00usb,rt2x00lib,iwlagn parport 34080 1 lp cfg80211 165732 3 rt2x00lib,iwlagn,mac80211 root@bt:~# modinfo rt2800usb filename: /lib/modules/2.6.39.4/kernel/drivers/net/wireless/rt2x00/rt2800usb.ko license: GPL firmware: rt2870.bin description: Ralink RT2800 USB Wireless LAN driver. version: 2.3.0 author: http://rt2x00.serialmonkey.com srcversion: 1BF0335B5467644CC4BAF13 alias: usb:v0586p341Ad*dc*dsc*dp*ic*isc*ip* . . . alias: usb:v07B8p2870d*dc*dsc*dp*ic*isc*ip* depends: rt2x00lib,rt2800lib,rt2x00usb vermagic: 2.6.39.4 SMP mod_unload parm: nohwcrypt:Disable hardware encryption. (bool) root@bt:~# dmesg | grep rt2800 [ 1080.970941] Registered led device: rt2800usb-phy1::radio [ 1080.970976] Registered led device: rt2800usb-phy1::assoc [ 1080.971005] Registered led device: rt2800usb-phy1::quality [ 1080.971229] usbcore: registered new interface driver rt2800usb
Disconnect the USB network card and try to use the wireless network card in the laptop does nothing to change the situation and the scripts are still not workingCode:root@bt:~# airmon-ng Interface Chipset Driver -> And the script does not stop and do nothing ^C // Finish the process manually root@bt:~# airmon-ng start wlan1 Found 5 processes that could cause trouble. If airodump-ng, aireplay-ng or airtun-ng stops working after a short period of time, you may want to kill (some of) them! PID Name 1229 dhclient3 1230 dhclient3 1747 wpa_supplicant 1762 dhclient 3568 dhclient Process with PID 1229 (dhclient3) is running on interface wlan0 Process with PID 1747 (wpa_supplicant) is running on interface wlan0 Process with PID 3568 (dhclient) is running on interface wlan1 Interface Chipset Driver -> And the script does not stop and do nothing ^C // Finish the process manually
Please help and thanks in advance
