Anyone to help?
Hi guys. I think that I have some problems (hardware?) with Alfa Awus036h and BT5 (KDE).
When I'm starting BT5 in my netbook with alfa plugged it it shows it only in iwconfig list. and not in ifconfig!! I saw another posts but I didn't get some help.
So, My internal wifi card is wlan0 and alfa is wlan1
If I type airmon-ng start wlan1 it says and it freezes!!:
and it freezes!Found 2 proccesses that could cause trouble.
If airodump-ng, aireplay-ng or airtun-ng stops working after
a short period of tie, you may want ot kill (some of) them!
Process with PID 1301 (dhclient3) is ruunnin on interface wlan0
Interface Chipset Driver
wlan1 Realtek RTL8187L rtl8187 - [phy0]
(monitor mode enabled on mon0)
After that I tried airmon-ng check kill and to try again the command. But it is still freezing!
Is there any way to find out the reason of this? Also sometimes wicd is freezing for some seconds when it tries to connect to my AP
I don't think that the card is damaged because I can connect to my AP. Is there any log file to check?
Maybe it's a conflict with my other internal card and I can't disable it.
Thanks in advance
Last edited by khaos; 09-16-2011 at 01:41 PM.
Anyone to help?
in MY laptop(kde 64) i had a similar problem and fix with:
(terminal) pyrhon-switcher --python26
after my wicd don't freeze!!
and try to put down WLAN0(if necessary) bye
Last edited by khaos; 09-17-2011 at 07:42 PM.
wicd is now fixed?
for your wlan0 i'dont know try:
airmon-ng stop wlan0
ifconfig wlan0 down
"iwconfig wlan0 txpower off" if your wlan0 chipset support set tx power (es:the rtl8187 ok)