Hello all

I've been hitting google hard the last few days with no results. I have a Intel wireless 6300 N card installed on my laptop but airmon or back track dont seem to see the chipset and version. I need some direction on getting the correct drivers installed to work with the aircrack suite. Any help or where to start would be greatly appreciated. The card will connect to my home access point and work fine although I cant seem to get the card into monitor mode or any functionality out of the aircrack-ng suite

I read in one place that i needed to update the firmware of the card and was directed to intelwirelesslinux.org. There I downloaded and copied the iwlwifi-ucode-6000 and copied it into /lib/firmware with no result


Code:
root@bt:~# ifconfig wlan0
wlan0     Link encap:Ethernet  HWaddr 00:24:d7:f3:d9:f0  
          inet addr:10.0.1.10  Bcast:10.0.1.255  Mask:255.255.255.0
          inet6 addr: fe80::224:d7ff:fef3:d9f0/64 Scope:Link
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:5546 errors:0 dropped:0 overruns:0 frame:0
          TX packets:4136 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000 
          RX bytes:3562497 (3.5 MB)  TX bytes:757472 (757.4 KB)
output from lspci
Code:
02:00.0 Network controller: Intel Corporation Centrino Ultimate-N 6300 (rev 35)
Code:
airmon-ng start wlan0
Interface	     Chipset		Driver