To start off I am new to backtrack. I am using backtrack 5 32bit hdd install. The problem I am running into is that when I type the airmon-ng command I don't get any results. As I am a beginner I am not looking for a quick answer but more of a point in the right direction to find it. Since I would like to learn why this problem is occurring. I have searched google and different wiki's but can't find an answer. I listed my output below.

root@bt:~# airmon-ng


Interface Chipset Driver

I didn't have a problem with this in ubuntu just after i installed backtrack. I do get an output with iwconfig and my wifi card works to get online.

root@bt:~# iwconfig
lo no wireless extensions.

eth0 no wireless extensions.

wlan0 IEEE 802.11bgn ESSID:"olegreg"
Mode:Managed Frequency:2.437 GHz Access Point: 68:7F:74:64:43:EA
Bit Rate=65 Mb/s Tx-Power=14 dBm
Retry long limit:7 RTS thrff Fragment thrff
Encryption keyff
Power Managementff
Link Quality=70/70 Signal level=-25 dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:1478 Invalid misc:9 Missed beacon:0

root@bt:~#