Trouble capturing IVs

[PrairieFire]

You might want to check ebay out for the dwl-g650 I have two, they are abundant and cheap.

[kaaslander]

hi

I have trouble to capture IVS from my own router.... it's a E-tech router.

I set my WEP security with 10 nummers.....

I have a rt2500usb lancard, backtrack 2.0 final will support it....

I don't know what the problem is.... it capture very very slow after 1 hour, I only got 200 IVS...( I have good signal of my router)

then I tried to used aireplay-ng to make some speed..

aireplay-ng -1 0 -e -b -h rausb0 ( fake succes)

aireplay-ng -3 -b -h rausb0 ( it resend very slow)

btw.... there aren't any celient op the network every pc was shut down..

any body idee to make some speed??

thanks

[shamanvirtuel]

i got a dwgl122C1 wich is rt73 i think it's pretty the same pb...
but i found solution

Enable the rausb0 interface.
ifconfig rausb0 up

iwpriv rausb0 forceprism 1 #Enable prism headers (to show power levels in airodump-ng)

iwpriv rausb0 rfmontx 1 #allow transmission in monitor mode (enables aireplay-ng attacks)

iwconfig rausb0 mode monitor #
airmon-ng start rausb0 #Put the card into monitor mode

the command in red is the most importante and must be typed before to monitor mode in order to work(for me).it allows card to transmit in monitor without this command card could only receive in monitor mode and not transmit

hope helps

[bound4h]

You're a godsend.

All is good now, thanks.

[shamanvirtuel]

i think it will make sense to do the two commands i gave you each time.....
helped many ppl i know here in france with this, dlink is one of first selling product in france, seemsthat all dlink using built in drivers need this commands for achieve attacks......

[kaaslander]

thanks dude i will try it out

[kaaslander]

i still capture the ivs very slow.... I have 38000 Beacons and I have only 200 IVS ....
I can't do any injecting......