sslstrip problem

[lagann]

I'm using bt4 r1 .....
I wanna ask about sslstrip ,especially about our target ...
usually I use sslstrip with single target ..then I think can we use 2 or more target with sslstrip?




Than'ks for any help

[comaX]

Of course you can if you set arpspoof or ettercap to target mutliple targets... I did a little script about that, check it out :
http://www.backtrack-linux.org/forum...utomation.html

[2901119]

when i use ettercap I do "ettercap -i <interface> -TqM ARP:REMOTE // //" in order to target my whole subnet

when i use arpspoof i just open up seperate terminals for each ip i want to target even though i know there is a couple ways to target multiple ips

[lagann]

Of course you can if you set arpspoof or ettercap to target mutliple targets... I did a little script about that, check it out :
http://www.backtrack-linux.org/forum...utomation.html

nice script,if it works I don't have to retype all the commands..
can u tell me where must i put that script...?