I have a broadcom bcm4306 and it is not finding ap's, even when I have a windows install and it see them fine.I had an install working with it, but don't remember how I got it.

Ifconfig looks like:
Code:
lo        Link encap:Local Loopback
          inet addr:127.0.0.1  Mask:255.0.0.0
          inet6 addr: ::1/128 Scope:Host
          UP LOOPBACK RUNNING  MTU:16436  Metric:1
          RX packets:130 errors:0 dropped:0 overruns:0 frame:0
          TX packets:130 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:0
          RX bytes:6648 (6.6 KB)  TX bytes:6648 (6.6 KB)

ppp0      Link encap:Point-to-Point Protocol
          inet addr:70.13.197.210  P-t-P:68.28.89.69  Mask:255.255.255.255
          UP POINTOPOINT RUNNING NOARP MULTICAST  MTU:1500  Metric:1
          RX packets:10000 errors:13 dropped:0 overruns:0 frame:0
          TX packets:8583 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:3
          RX bytes:9510203 (9.5 MB)  TX bytes:1119566 (1.1 MB)

wlan0     Link encap:Ethernet  HWaddr 00:90:4b:2c:a6:4d
          UP BROADCAST  MTU:1500  Metric:1
          RX packets:0 errors:0 dropped:0 overruns:0 frame:0
          TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000
          RX bytes:0 (0.0 B)  TX bytes:0 (0.0 B)
(I'm connected through ppp0)

And iwconfig looks like

Code:
lo        no wireless extensions.

wlan0     IEEE 802.11bg  ESSID:off/any
          Mode:Managed  Access Point: Not-Associated   Tx-Power=20 dBm
          Retry  long limit:7   RTS thr:off   Fragment thr:off
          Encryption key:off
          Power Management:off

ppp0      no wireless extensions.
When I put it into monitor mode with airmon-ng, it creates mon0. I use that with airodump-ng, and it starts up fine. But never finds any networks. I tried using the guide in the how-to's demonstrating how to use jockey-gtk to make it work, and it says all is good.