Senao 2511CD. Packet Injection not working on Hostap
I got here a card with a Prism2.5 card.
Everything on it is working well, but not the most importang Packet Injection.
I tried the BTf2 and BTf1 (with the latest aircrack-ng) but without any difference.
I use the hostap drivers. (interface wlan0)
and flashed the card successfull to v1.7.4.
Even if i get some ARP requests after successfull aireplay-ng -1 and after a time some ARP req. on aireplay-ng -3, the ARP request don't grow up, but the packets are sending and the signal is very good (my AP is not even 1m from me).
After a time the I get maybe like 30IVs/sec. But anyway something is really wrong on this card.
I see that lot of people got that problem with that card and to make the card Packet-Injection.
But I could not find any fix for that problem. ;(
Any ideas what could I try to make the card working well in packet injection?
i got that card same firmware no problems. did you change you mac when using aireplay-ng -1 try a test on your router. open your command prompt on your win OS and ping 192.168.0.9 the arp should go up then. i also use -x 1000 in aireplay-ng -3 which helps too.
when you boot to B|T2 keep your card in.
login in - root/toor.
physically eject your card, or issue the eject card command
while it's out enter the following
stick your card back in. airmon-ng start wlan0. now you should be all set.
mkdir /home/root -to make a dir for use with airoscript. then run it
that's what I do, and I don't have any probs. You can edit airoscript.sh to inject x1000 like mentioned earlier.
I have the same problem.
and reinserting the card BT2 loads again the orinoco drivers for the card.
I've edited the etc/pcmcia confs, (which worked in BT1) but that does not help.
Please help - I'm desperate.
I have a Netgear MA401 and a Senao Card.
Both don't work.
waldviertler, have you tried blacklisting the drivers and commenting hostap_cs also did you get any errors when removing those drivers.
when you boot into B|T make sure your card is in.
then eject, then rmmod the drivers, then modprobe hostap_cs, then re-insert.
is that the process you're following?
Thanks to both seniors!
After blacklistening the orinoco and hermes drivers in etc/hotplug/blacklist and uncomment the hostap in etc/modprobe.d/blacklist
both cards were not shown anymore.
And when I modprobe hostap_cs now, I get with lsmod | hostap
hostap_cs 56500 0
hostap 107540 1 hostap_cs
When I boot into B|T with the card in, and doing like you told me, I got the same result:
F* Orinoco drivers are loaded.
HEY waldviertler, if you would of listened to what i said. i said comment hostap_cs . your hostap driver was blacklisted, so why would you think it would load up on its own.
# blacklist hostap_cs
No, I have done this also and it don't work.
it is work fine ,,, thanks guys