I have a Netgear wg511t wireless up on my Sager 4750V x86-64 laptop.

Please explain from my demsg:
wifi0: Use hw queue 1 for WME_AC_BE traffic
wifi0: Use hw queue 0 for WME_AC_BK traffic
wifi0: Use hw queue 2 for WME_AC_VI traffic
wifi0: Use hw queue 3 for WME_AC_VO traffic
wifi0: Use hw queue 8 for CAB traffic
wifi0: Use hw queue 9 for beacons

so I can take full advantage of the card.

Thanks.

Yep, I have searched; but all I get is other folks dmesg's.

I have it up automatically by adding:

1. to SuSE Grub boot line for BT2: "acpi=noirq nodhcp ro"
acpi=noirq, because I evidently had an acpi irq conflict with my atheros card
nodhcp, because I wanted to save a step & faster booting
ro, (vs rw) as I was getting a boot message telling me to.

2. edited /etc//etc/rc.d/rc.local & added:
ifconfig eth0 down
ifconfig ra0 down
modprobe ath_pci
iwconfig ath0 essid "default"
iwconfig ath0 nick "laptop"
iwconfig ath0 rate 54M
iwconfig ath0 mode Managed
iwconfig ath0 freq 2.437G channel 6
iwconfig ath0 key mykey
ifconfig ath0 up
route add default gw mygateway
dhcpcd ath0

Works like a champ!!!