Wireless card problem

[Blackadder907]

I have Acer Aspire 5741G with Broadcom wireless card and when I use aircrack I don't have wlan0 but eth0 and under Chipset says Unknown, so I can't use aircrack. I tried it on another computer and it's working. Is there any patch, driver or anything else what I should install?

[killadaninja]

Try

lspci -nn

Post the results. This question should really be searched over at aircrack-ng.

[Blackadder907]

00:1f.5 IDE interface [0101]: Intel Corporation 5 Series/3400 Series Chipset 2 port SATA IDE Controller [8086:3b2d] (rev 05)
00:1f.6 Signal processing controller [1180]: Intel Corporation 5 Series/3400 Series Chipset Thermal Subsystem [8086:3b32] (rev 05)
01:00.0 VGA compatible controller [0300]: ATI Technologies Inc Device [1002:68e0]
01:00.1 Audio device [0403]: ATI Technologies Inc Device [1002:aa68]
02:00.0 Ethernet controller [0200]: Broadcom Corporation NetLink BCM57780 Gigabit Ethernet PCIe [14e4:1692] (rev 01)
03:00.0 Network controller [0280]: Broadcom Corporation Device [14e4:4357] (rev 01)
ff:00.0 Host bridge [0600]: Intel Corporation Core Processor QuickPath Architecture Generic Non-core Registers [8086:2c62] (rev 02)
ff:00.1 Host bridge [0600]: Intel Corporation Core Processor QuickPath Architecture System Address Decoder [8086:2d01] (rev 02)
ff:02.0 Host bridge [0600]: Intel Corporation Core Processor QPI Link 0 [8086:2d10] (rev 02)
ff:02.1 Host bridge [0600]: Intel Corporation Core Processor QPI Physical 0 [8086:2d11] (rev 02)
ff:02.2 Host bridge [0600]: Intel Corporation Core Processor Reserved [8086:2d12] (rev 02)
ff:02.3 Host bridge [0600]: Intel Corporation Core Processor Reserved [8086:2d13] (rev 02)

[Blackadder907]

I tried BT3 and when I tipe airmon-ng there are no results. Perhaps I should wait BT5?

[Archangel-Amael]

BT 3 is no longer supported. Upgrade to 4 final.