airodump-ng mon0 vs. airodump-ng wlan0

[jodeme]

Hi. If i do

airmon-ng start wlan0 && airodump-ng mon0

and it scans worse (only 1 or 2 APs appear) than doing directly

airodump-ng wlan0

(appear all APs around )
What may cause trouble to scanning on mon0? The card is ALFA, rtl8187 is the driver.

[voidnecron]

@Mods: Correct me if I'm wrong.
mon0 is an 'alias' of wlan0 in promiscious mode to sniff/intercept traffic, so scanning the area twice with physicly the same interface might cause collisions on the interface.
You can't have the same interface scanning different channels at the same time.
Either capture with mon0 or wlan0, not both.

[BoogY]

@Mods: Correct me if I'm wrong.
mon0 is an 'alias' of wlan0 in promiscious mode to sniff/intercept traffic, so scanning the area twice with physicly the same interface might cause collisions on the interface.
You can't have the same interface scanning different channels at the same time.
Either capture with mon0 or wlan0, not both.

Actually yes it's the same interface.

[jodeme]

oops. i was connected to my AP on wlan0 and trying to scan on mon0. That caused trouble )) I was damn sure it became possible in BT4. There was not any mon0 alias in BT3 and dumbs like me could not do it.

[NoaHjk]

I don't get what's the difference between wlan0 and mon0. From some reason I can't get me assiciated with the AP while I'm using wlan0(got open system something error). With mon0 it works just fine.

Do I get mon0 only for wlan0 or there is mon0 wirh rausb0 as well?

[calychu]

hi try to do this

#airmon-ng start wlan0

"must appear that the interfaz mon0 its in mode monitor enabled"

#airmon-ng mon0

"must work correctly and you can see the networks availables

[Barry]

I don't get what's the difference between wlan0 and mon0. From some reason I can't get me assiciated with the AP while I'm using wlan0(got open system something error). With mon0 it works just fine.

Do I get mon0 only for wlan0 or there is mon0 wirh rausb0 as well?

Using wlanconfig

[Lincoln]

http://www.aircrack-ng.org/doku.php?...ee80211_stacks

[TAPE]

Using wlanconfig

Isnt that only used for VAPs ?