i want to install driver for realteak8139d and i used ndiswrapper.when i installed the inf file and later hit the following commnads i get the following output.

veekram@veekram-desktop:~$ lshw -C network
WARNING: you should run this program as super-user.
*-network
description: Ethernet interface
product: RTL8139D [Realtek] PCI 10/100BaseTX ethernet adaptor
vendor: Hangzhou Silan Microelectronics Co., Ltd.
physical id: 9
bus info: pci@0000:01:09.0
logical name: wlan0
version: 01
serial: 00:a1:b0:20:7e:70
width: 32 bits
clock: 33MHz
capabilities: bus_master cap_list ethernet physical
configuration: broadcast=yes driver=ndiswrapper+netslnt driverversion=1.55+Sltek Inc.,04/05/2002, 1.0. ip=192.168.1.2 latency=32 maxlatency=40 mingnt=20 module=ndiswrapper multicast=yes
veekram@veekram-desktop:~$

veekram@veekram-desktop:~$ ifconfig
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:224 errors:0 dropped:0 overruns:0 frame:0
TX packets:224 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:17160 (17.1 KB) TX bytes:17160 (17.1 KB)

wlan0 Link encap:Ethernet HWaddr 00:a1:b0:20:7e:70
inet addr:192.168.1.2 Bcast:192.168.1.255 Mask:255.255.255.0
inet6 addr: fe80::2a1:b0ff:fe20:7e70/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:6 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 B) TX bytes:468 (468.0 B)
Interrupt:21 Memory:ff8fec00-ff8fed00

veekram@veekram-desktop:~$



ANyone tell me how to configure the driver??