Card cant see networks in BT3.

[shammon]

Hi,
Ok using the Netear WG511T with back track 3
The card is working ok in the wireless assistant and can see the wifi near by.
It also connects okay to the internet.

Now when I log on to the shell and do the following commands below, When I get to the part where it shows you the Wifi signals it has picked up there is none despite there being ones close by inc mine in the same room from the router.

have checked the fourm and ask if some one can guide me as to the correct input int he shell command promt to see if I can get it to work here is what I am currently doing. Thanks excuse my noob to this I have looked and need some expert advice as I am stuck. Thankyou.

bt ~ # airmon-ng


Interface Chipset Driver

wifi0 Atheros madwifi-ng
ath0 Atheros madwifi-ng VAP (parent: wifi0)

bt ~ # airmon-ng stop ath0


Interface Chipset Driver

wifi0 Atheros madwifi-ng
ath0 Atheros madwifi-ng VAP (parent: wifi0) (VAP destroyed)

bt ~ # ifconfig wifi0 down
bt ~ # macchanger --mac 00:11:22:33:44:55 wifi0
Current MAC: 00:09:5b:c1:df:3c [wireless] (Netgear MA701, MA401RA)
Faked MAC: 00:11:22:33:44:55 (Cimsys Inc)
bt ~ # airmon-ng start wifi0


Interface Chipset Driver

wifi0 Atheros madwifi-ng
ath0 Atheros madwifi-ng VAP (parent: wifi0) (monitor mode enabled)

bt ~ #airodump-ng wifi0


THEN itfails to show any networks.....

[shammon]

Solved

used bt4