ok I started trying to use airodump, but I cant seem to get off the ground. Essentially all the commands I try to run say i need to enable a device. I tried to do that... I think. Here's what it said:

root@bt:~# airodump-ng wlan0
ioctl(SIOCSIWMODE) failed: Device or resource busy

ARP linktype is set to 1 (Ethernet) - expected ARPHRD_IEEE80211,
ARPHRD_IEEE80211_FULL or ARPHRD_IEEE80211_PRISM instead. Make
sure RFMON is enabled: run 'airmon-ng start wlan0 <#>'
Sysfs injection support was not found either.

I used iwconfig to pick that wlan0 idk if that right