how far away from the router and client are you?
I have tried it again this few days but I still cannot capture the WPA handshake.
The reply from the system is as follow:
Sending 64 directed DeAuth. STMAC: [00:16:EA:C8:27:30] [0| 0 ACKs]
What have I done wrong?
I try to patch the new driver into the Wireless adaptor but it just gives me error: "drivers/net/wireless/zd1211rw/zd_mac.c", No such file or directory...
Previous discussion please refer to the following link:
My client (victum) is just next to my attacking laptop... less then 10CM
My wireless router is just 1M away...
what wireless card are you using? please print your airmon-ng, ifconfig output's and will see whats going on.
Code:ifconfig eth0 Link encap:Ethernet HWaddr 00:0C:29:72:24:0B inet addr 192.168.223.129 Bcast: 192.168.233.255 Mask 255.255.255.0 UP BROADCAST NOTRAILERS RUNNING MULTICAST MTU:1500 Metric:1 RX packets:55 errors:0 dropped:0 overruns:0 frame:0 TX packet:5 error:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:1000 RX bytes:8338 (8.1KiB) TX bytes:1344 (1.3KiB) Interrupt:18 Base address:0x2000 eth1 Link encap: UNSPEC HWaddr 00-0E-3B-0A-43-61 UP BROADCAST NOTRAOLERS RUNNING PROMISC ALLMULTI MTU:1500 Metric:1 RX packets:39930 errors:28483 dropped:0 overruns:0 frame:28483 TX packets:38056 error:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:1000 RX bytes: 6359789 (6.0MiB) TX bytes: 950672 (928.3 KiB) lo --> Loopback (Omited)Code:airmon-ng start eth1 Found 1 processes that could cause trouble. If airodump-ng, aireplay-ng or airtun-ng stops working after a short period of time, you may want to kill (some of) them! PID Name 3451 dhcpcd Interface Chipset Driver eth1 ZyDAS 1211 zd1211rw (monitor mode enable)
what wireless card are you using? usb or bilt in? if built in, what computer are you using? please print your airmon-ng output,
I am using HWU8DD
Driver: Rev.B: zd1211rw
Chipset: Rev.B: zd1211b
It is a wireless USB adaptor...
Data obtain from:
But last week I can use this equipments to capture packet and crack the WEP key within 14 mins!Code:aireplay-ng --test eth1 06:20:49 Trying broadcast probe requests... 06:20:51 No Answer... 06:20:51 Found 0 APs
ok injection isn't working so you need to ether re patch the driver with hxxp://patches.aircrack-ng.org/zd1211rw_inject_2.6.26.patch 2.6.26 being your kernel, check your kernel by using uname if its different change the link and see if there is one for your kernel,,,
capturing wep is really just listening for the packets and de authenticating is sending packets to the client hence injecting,