How to configura WPA Supplicant with RTL8187 USB CARD

[spigolo]

Hi
How to configure wpa_supplicant with rtl8187 usb 2.0 wireless card in Back Track?
If I open the wpa_supplicant GUI search the driver for the network card.
Thanks
Spigolo

[xorred]

configure it through the command line and start it through the command line. the gui is not functional in bt3. And in bt4... there is network manager

[kazalku]

Hi
How to configure wpa_supplicant with rtl8187 usb 2.0 wireless card in Back Track?
If I open the wpa_supplicant GUI search the driver for the network card.
Thanks
Spigolo

Are you after these commands, if so then try it.........
**password** means enter your AP password here (without **)
same with **put essid**

ifconfig rausb0 down
macchanger -m 00:11:22:33:44:55 rausb0
ifconfig rausb0 up 
iwconfig rausb0 mode managed
iwconfig rausb0 essid **put essid**
iwpriv rausb0 set AuthMode=WPAPSK
iwpriv rausb0 set WPAPSK=**password**
iwpriv rausb0 set EncrypType=TKIP
dhcpcd rausb0

[spigolo]

Ok Perfetct
Thanks

[Araquera]

Did that work for you Im having A lot of trouble connecting to my WPA router with my dlink DWA-110 and my 4965agn, both work under aircrack perfectly, but i cant connect to wpa networks, if i use wlassitant i get FAILED connection constantly, and a wpa error in shell.

Loaded application options.
All interfaces: eth0, pan0, wlan0, wlan1, wmaster0, wmaster1
Wireless interface(s): wlan0, wlan1
Permissions checked.
DHCP Client: dhclient
All executables found.
scan: /sbin/iwlist wlan0 scan
Networks found: 2
Selected interface: wlan1
scan: /sbin/iwlist wlan1 scan
Networks found: 2
ACTION: CONNECT.
No DHCP client running.
No pre-connection command specified.
iwconfig_set: /sbin/iwconfig wlan1 mode managed channel 6 key off essid Araque
iwconfig_ap: /sbin/iwconfig wlan1 ap 00:18:39:6F39
==>stderr: Failed to connect to wpa_supplicant - wpa_ctrl_open: No such file or directory
Using wpa_supplicant driver: wext
WPA client started. Waiting for status...
==>stderr: Failed to connect to wpa_supplicant - wpa_ctrl_open: No such file or directory
CONNECTION FAILED.
disconnect: /sbin/iwconfig wlan1 mode managed key off ap off essid off

[imported_cybrsnpr]

I could be mistaken, but I'm under the impression that if you want to connect to a WPA network using the rt8187 drivers in BT3, you need to use the ndiswrapper driver. This problem is fixed in BT4.

[Padawan]

rt8187 + wpa_supplicant = not work (BT3).
I tried the ndiswrapper driver, it does not work either.
I'm also an rt8187 owner and I've seen this question coming several times.

[imported_blackfoot]

This is a Ralink, no?

Use wpa_passphrase to create your password key

Then use iwpriv to assign the mode WPA or WPA2 and use the aforementioned password key