Results 1 to 4 of 4

Thread: cannot center screen

  1. #1
    Junior Member
    Join Date
    Sep 2008
    Posts
    85

    Default cannot center screen

    ok i finally got BT3 to boot on my system (using a CD instead of a flashdrive) but i can't get the desktop horizontally centered on my screen... i fully adjusted my monitor to the best fit, but i still dont get all of the desktop... any advice?

  2. #2
    Just burned his ISO
    Join Date
    Oct 2008
    Posts
    16

    Default

    I had that problem, are you using an ATI graphics card? if so I had to install the correct drivers to get the display res correct.

  3. #3
    Just burned his ISO
    Join Date
    Oct 2008
    Posts
    14

    Default

    Also have an ATI Graphics card - Same trouble. I found that the card works fine w/ a DVI output - it is only the analog output that causes problems.

    Hope that is useful in some way.

  4. #4
    Just burned his ISO
    Join Date
    Oct 2008
    Posts
    16

    Default

    Check the display resolution the BT3 is using I bet it higher than you monitor.

    if that is the case you have two choices (that i know of) fix the display driver or start bt3 using the 1024x768 vesa driver.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •