Need with the Belkin N1 Wireless ExpressCard
read up and heard that I need to get the madwifi svn r2834, searched it on google and the madwifi site and I can't find.
I tried modprobe ath_pci cause i'd think BT3 would have a recent release of the madwifi drivers.
I also tried getting the updated madwifi drivers through their svn by doing
svn co http://svn.madwifi.org/madwifi/trunk
make && make install
and still nothing...
What's the proper driver for this expresscard?
Could you guys help me out. I tried the 3008 drivers and still no go. I know that some of you guys have the Belkin N1 ExpressCard working out there. I know that the module is ath_pci. However, I've tried getting the drivers from the madwifi site and there's no luck. What exactly did you guys do to get this bad boy to work?
Under lspci, it reads as
Network controller: RaLink Unknown device 0681
The revision on my card is v3000
when its ralink chipset then why you are installing atheros chipset drivers on it and this cards works perfactly on bt3.try to attach this card after properly booting bt3 and then give it a try.also search this forum.there is many threads regarding it.
Good call, thanks. I'm learning.
Nice got it working. modprobe rt2860sta works great.
The card was working great for a while. Then when I rebooted my computer, things started to go bad. It changes to and from monitor mode fine. However, when I run airodump-ng ra0 it outputs the labels but there is no wireless card input e.g. no routers being captured when there should be. However, it does output a client's mac address next to a router's mac down at the bottom. I'm gonna try the other modules on the ralink site.