Broadcom 4312 not working with airodump-ng on Ubuntu 8.10
OK so I haven't been able to get my Broadcom bcm4312 working on Backtrack 3 on a new HP Mini 1030NR (a problem for another post) so I'm running Ubuntu 8.10 and am able to use Wifi normally on my network (internet and such) but ipconfig shows:
eth0 Link encap:Ethernet HWaddr 00:23:4e:41:a3:d1
inet addr:192.168.0.102 Bcast:192.168.0.255 Mask:255.255.255.0
inet6 addr: fe80::223:4eff:fe41:a3d1/64 Scope:Link
UP BROADCAST RUNNING MTU:1500 Metric:1
RX packets:17516 errors:0 dropped:0 overruns:0 frame:28884
TX packets:8951 errors:46 dropped:0 overruns:0 carrier:0
RX bytes:17788819 (17.7 MB) TX bytes:1041720 (1.0 MB)
Interrupt:16 Base address:0xc000
eth1 Link encap:Ethernet HWaddr 00:22:64:72:92:77
UP BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:135 errors:0 dropped:0 overruns:0 frame:0
TX packets:135 errors:0 dropped:0 overruns:0 carrier:0
RX bytes:7624 (7.6 KB) TX bytes:7624 (7.6 KB)
And when I run airodump (with whatever parameters):
ARP linktype is set to 1 (Ethernet) - expected ARPHRD_IEEE80211,
ARPHRD_IEEE80211_FULL or ARPHRD_IEEE80211_PRISM instead. Make
sure RFMON is enabled: run 'airmon-ng start eth0 <#>'
Sysfs injection support was not found either.
I've tried running airmon as stated above (without the number after eth0- what does that mean?) and it hasn't helped.
I've searched around and haven't been able to find anything relevant to my problem. Any ideas? Or can anyone redirect me to somewhere with an answer?
I believe you may get a better response to your question if you ask it here- http://ubuntuforums.org/.
This is a forum for BackTrack and many of the more senior members tend to get a mite tetchy when people ask questions unrelated to the OS in question.