cannot center screen
ok i finally got BT3 to boot on my system (using a CD instead of a flashdrive) but i can't get the desktop horizontally centered on my screen... i fully adjusted my monitor to the best fit, but i still dont get all of the desktop... any advice?
I had that problem, are you using an ATI graphics card? if so I had to install the correct drivers to get the display res correct.
Also have an ATI Graphics card - Same trouble. I found that the card works fine w/ a DVI output - it is only the analog output that causes problems.
Hope that is useful in some way.
Check the display resolution the BT3 is using I bet it higher than you monitor.
if that is the case you have two choices (that i know of) fix the display driver or start bt3 using the 1024x768 vesa driver.