Please Help! Wusb54gc Intermitant Handshake Trouble

[slim76]

PLEASE! PLEASE! PLEASE! can some one help me fix this problem i have capturing my wpa handshake!
I would be most grateful for any possible help that anyone could offer!

I have a netgear router that i got from SKY Broadband, its encrypted using wpa.
Im using Linksys WUSB54GC and the chip inside it says: RT2571WF
I have a Acer Travelmate 290 with built in intel wireless card (ipw2200)

Ive done a fresh install of bt2final which i had updated with the fixed sqlite, Then i updated aircrack-ng to Aircrack-ng 1.0 r735.
Then i used airdriver-ng to remove all the other drivers except for these ones:

Found following stacks installed:
0. IEEE80211
1. IEEE80211 Softmac
Found following drivers installed:
3. Atmel at76c50x - IEEE80211 I TRIED TO REMOVE THIS ONE TOO, BUT I COULD NOT
9. Intel Pro Wireless 2100 B - IEEE80211
10. Intel Pro Wireless 2200 B/G - IEEE80211
11. Intel Pro Wireless 3945 A/B/G - IEEE80211
43. NDIS Wrapper

Then i rebooted my laptop.

Then i installed the new rt73-k2wrlz-2.0.0.tar.bz2 driver using these commands:
cd module
make
make install

Then i checked to make sure the new driver was installed using airdriver-ng:

Found following stacks installed:
0. IEEE80211
1. IEEE80211 Softmac
Found following drivers installed:
3. Atmel at76c50x - IEEE80211
9. Intel Pro Wireless 2100 B - IEEE80211
10. Intel Pro Wireless 2200 B/G - IEEE80211
11. Intel Pro Wireless 3945 A/B/G - IEEE80211
31. Ralink rt73 (legacy)
43. NDIS Wrapper

Then i reboot

Then i connect to my AP using my onboard intel wireless card (ipw2200)

Then i do:

ifconfig rausb0 up
airmon-ng start rausb0 11
airodump-ng -c 11 -w psk --bssid APMAC rausb0
aireplay-ng -0 1 -a APMAC -c CLIENTMAC rausb0


IVE TRIED THESE DRIVERS

rt73-k2wrlz-1.0.0.tar.bz2: I cant remember the trouble with this one, but i didnt work for me!
rt73-k2wrlz-1.1.0.tar.bz2: This driver does not disconnect the connected client so no handshake.
rt73-k2wrlz-2.0.0.tar.bz2: This driver disconnects the client every time but only captured the handshake sometimes. (VERY RARELY)

AIREPLAY INJECTION TEST USING rt73-k2wrlz-2.0.0.tar.bz2

bt ~ # aireplay-ng --test rausb0
16:02:23 Trying broadcast probe requests...
16:02:23 Injection is working!
16:02:25 Found 2 APs

16:02:25 Trying directed probe requests...
16:02:25 00:00:00:00:00:00 - channel: 11 - 'SKY43233'
16:02:28 Ping (min/avg/max): 0.018ms/52.116ms/147.406ms Power: 107.52
16:02:28 21/30: 70%

16:02:28 00:00:00:00:00:00 - channel: 11 - 'SKY18537'

[shamanvirtuel]

i use 1.1.0 driver not 2.0.0 wich is strangely based on an older reliz of the driver than 1.1.0

1.1.0 allows capture handshake & fragmentation but have prism headers disabled (can cause pb) so pwr output may be screwed...but it's nothing

this driver is the most stable i know for rt73.....

i got 2 wusb54gc and i have no pb with this driver....

so try it

[slim76]

I used rt73-ASPJ-1.1.0.tgz which installed rt73 rt2500 rt2570 and rt61and i installed it by using installpkg rt73-ASPJ-1.1.0.tgz
Then i done:
modprobe rt73
ifconfig rausb0 up
iwconfig rausb0 mode monitor channel 11 rate 1m
iwpriv rausb0 rfmontx 1
airodump-ng -c 11 -w psk --bssid 00:00:00:00:00:00 rausb0
aireplay-ng -0 1 -a 00:00:00:00:00:00 -c 00:00:00:00:00:00 rausb0

[shamanvirtuel]

with this driver you don't need to iwpriv rausb0 rfmontx 1

this is activated by default....

so just need to do for a complete setup
CLI="00:11:22:33:44:55" (variable declaration for client mac)
CHAN=10 (same for channel)

ifconfig rausb0 down && rmmod rt73 && modprobe rt73 && macchanger --mac $CLI rausb0 && ifconfig rausb0 up && iwconfig rausb0 mode monitor channel $CHAN rate 1M && aireplay-ng --test rausb0 -B

this commands will down card, reload driver, macchange the card to client mac via the variable $CLI, set channel via $CHAN and test all bitrates for injection

but this is ok only with latest aircrack-ng suite

use my updater software for this.....

[svenson]

hi,

got same card but other problem...

fakeauth is working like a charme and aireplay-ng -9 -B rausb0 outputs me 100% injection on all rates..bute when i began to arpreplay he stop at
you should start airodump-ng to capture packets.....
thats all..

even if i do fragmantation attack it stop at this line!!??!?

any suggestion`????