Getting WG511T to work in BT2

[Celyst]

I previously tried to get my WG511T to work in BT1 and was advised to switch to BT2. However, my card only works in BT2 if I run it with options "bt irqpoll acpi=off".

I don't really like the acpi to be set off, so is there a way to get my network card working in BT2 and yet not give up on ACPI? Without it I have absolutely no idea when my battery will die out.

[Celyst]

Erm, help?

I've read this thread on ACPI modules and I did try some of the commands, but I got a "FATAL: module not found" error. Then again, I don't think it would work since I started BT with the acpi=off option.

So, what's the secret to getting WG511T and ACPI working at the same time? Or it's impossible?