Inguma gui crashes

[_hap_]

Some modules run fine whilst others quickly close/crash the gui.

[KMDave]

Some more info on which modules are causing the crash would be appreciated.

[_hap_]

Started out trying the 1st module 'arping' and it crashes instantly ... then went further down and tried 'netcraft' which causes another crash. Also tried double clicking a few modules and that caused a crash. This could be bugs in inguma itself?

[Dr_IDE]

KMDave,

I am having the same issues. Pretty much all of the modules are causing hard crashes in python for me.

Details:
BT4-PreFinal running on VMWare Server 2.0.0 tried as both root and User

Upon startup there is the following error also:

$No module named cx_Oracle

Upon Crashes here is a sample message:

(Ftp Fuzz Module)
$python: ../../src/xcb_lock.c:77: _XGetXCBBuffer: Assertion `((int) ((xcb_req) $- (dpy->request)) >= 0)' failed.
$Aborted

(ARP Ping)
$Segmentation Fault

(Ping) (localhost, Port 0)
$.......Segmentation Fault

(Ping) (172.x.x.x, Port 0)
$..*Segmentation Fault

Could be user error on my part, but none of the errors seem handled in any way.

Hope this is more helpful.

[KMDave]

Thanks for the more detailed explanations

The issue will be investigated and fixed.

[Archangel-Amael]

Sorry for digging up an old thread but,
I tried messing around with the inguma gui and I too got the segmentation faults as above among several other miscellaneous, and various error messages. I installed the other versions available at sourceforge and they all seemed to do the same thing.
Since there is not a lot of development for the gui it may just be best to leave it alone and use only the command line. I have had no problems with it at all.
Not to mention that the gui really does not provide anything that the command line can't already do.