cant connect with broadcom

[gaunt1969]

I cant get my broadcom to take a (bssid) but it will take a key


bt ~ # airmon-ng stop eth1


Interface Chipset Driver

eth1 Broadcom bcm43xx (monitor mode disabled)

bt ~ # ifconfig eth1 up
bt ~ # iwconfig eth1 ap 00:21:1E:40:B4:90
bt ~ # iwconfig eth1 key AC:06:3B:F5:62:AF:CD:A4:25:96:6B:67:3A
bt ~ # dhcpcd eth1
bt ~ # iwconfig
lo no wireless extensions.

eth0 no wireless extensions.

eth1 IEEE 802.11b/g ESSIDff/any Nickname:"Broadcom 4311"
Mode:Managed Frequency=2.457 GHz Access Point: Invalid
RTS thrff Fragment thrff
Encryption key:AC06-3BF5-62AF-CDA4-2596-6B67-3A Security modepen
Link Quality=0/100 Signal level=-256 dBm Noise level=-256 dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0


I know it has to be something simple that I am missing.

[purehate]

Its hard to help someone that doesn't even bother to read the forum rules when applying to be a member. Maybe you should give them a re read paying special attention to the section on new member posts.

[gaunt1969]

If you are talking about the cross post where I tryed to resend my post after not seeing it appear in the newbie area "where i was trying to post per the rules" then sorry that the tagg saying something about my post will be reviewed by a mod or something first: only flashed up for about 2 seconds and I was only able to vaguely catch enough few words the second time around to tell enough about what it said and that i would have to wait. But I dont controll the time that little tagg stays up after the submit button is pushed.

If you dont have anything to contribute to my post dont reply at all to it.

[balding_parrot]

If you are talking about the cross post where I tryed to resend my post after not seeing it appear in the newbie area "where i was trying to post per the rules" then sorry that the tagg saying something about my post will be reviewed by a mod or something first: only flashed up for about 2 seconds and I was only able to vaguely catch enough few words the second time around to tell enough about what it said and that i would have to wait. But I dont controll the time that little tagg stays up after the submit button is pushed.

It is quite clearly stated in the forum rules, so the popup excuse is not valid at all.
Here it is in case you missed it

New registrants posts will be moderated first, causing a slight delay in the post appearing

also

Do not cross-post - 1 post in the relevant area is enough!

If you dont have anything to contribute to my post dont reply at all to it.

I am not contributing to "your" post and will reply to it if I like.
If you cannot follow the rules or be civil to the moderators who are only doing their "job" then do not post at all.

[gaunt1969]

and I was no more uncivil than what was to me; the same should go to mods also

[killadaninja]

If you are talking about the cross post where I tryed to resend my post after not seeing it appear in the newbie area "where i was trying to post per the rules" then sorry that the tagg saying something about my post will be reviewed by a mod or something first: only flashed up for about 2 seconds and I was only able to vaguely catch enough few words the second time around to tell enough about what it said and that i would have to wait. But I dont controll the time that little tagg stays up after the submit button is pushed.

If you dont have anything to contribute to my post dont reply at all to it.

1. You clearly state

the tagg saying something about my post will be reviewed by a mod or something first: only flashed up for about 2 seconds and I was only able to vaguely catch enough few words.

Well them few words you catched was the all important ones and you ignored them.

2.

If you dont have anything to contribute to my post dont reply at all to it.

Im surprised you got away with talking to pureh@ate like that.