nice, i shall try it

thx zambuka42

thx tim..one more question..how do i put it in my path? and thanks zambuka42 for the instructions on the fix.

after installin aircrack-ptw and gettin all the packets is there anythingelse i need to do before i run aircrack-ptw or do i just open a command prompt and type in aircrack-ptw <filename>.cap? thanks

hi all,
my sound and mouse does not work,
i was wondering can it be due to drivers,
if so how can i find out which drivers i need and where to get them?
thanks

nice baxter and thx for dis i shall try it out

thx elliot

can any1 write a step-by-step on how to do this?
how to compile it?
and is it just the -lpcap part we move?
thanks

eject your card and put in these commands

rmmod orinoco_cs
rmmod orinoco
rmmod hermes
modprobe hostap_cs

then reinsert your card and airmon-ng start wlan0
it was on the wiki

thx, ya i shoulda tried sry bout that

how to get the other look instead of the red box and how he change the settings on it.

could u explain how u did that plz, thank you

hi all, i had just installed bt2 final and after configuring lilo the labels and timeout had no effect after reboot but when i open lilo.conf again the changes i made had saved in there. i had done...

how did u fix the problem can u explain, ty

on step 2 try putting: airmon-ng start eth1 3
and your aircrack file in your command should be capture-01

must eject card then input the commands then re-insert card