Can anybody check if you get any errors after running

command.
I have done

Metasploit starts without errors, but nmap help shows

After getting wireshark done and working I receive a message about running it under root and lua error load. Solution for this is to run under non root user or modify some config file for lua....

I will run with the method above, however there is one problem. If you run for instance db_nmap -help you will get the following:


I did not run , instead I have used
If you run than for any...

same problem. Updated metasploit and got same error

Hi,

I have downloaded BT5 R1. Trying to start openvas while following FAQ. However when I am trying to start Greenbone Security Desktop i am getting the following message:

You are connected to...

Same problem here with running psnuffles. Cannot find any resolution for this problem. Those solutions mentioned earlier does not work.

Edit:

I have seen that somebody tried to post it as a bug...

Oh my, it was just me incredibly blind and stupid. Should have used nmap and not db_nmap.

Hey,

I am again stuck. Last week command in msfconsole:

worked fine and all three output type files were created fine.

I did not do any changes. Booted today backtrack, run a command

And...

Oh, hi.

I am sorry I did not reply on Dradis forum. Your solution worked as charm. Thank you very much for help

Hi All,

I am going through Metasploit unleashed course. Installed BT5 and got stuck at dradis framework and unfortunately cannot find answer on Dradis webpage. It seems that BT5 comes with newer...