Here is a Snapshot :
First i start Backtrack 2,because i will work with qparted
then i start a new Terminal .
bt ~ # mount
tmpfs on / type tmpfs (rw)
proc on /proc type proc (rw)
sysfs on /sys type sysfs (rw)
usbfs on /proc/bus/usb type usbfs (rw,devgid=10,devmode=0666)
/dev/hdc1 on /mnt/hdc1 type ext3 (rw,noatime)
bt ~ # umount /dev/hdc1
bt ~ # qtparted
1. I Delete my Partition
2. I create a new primary Partition which is 3815.92 MB in ext3 with Label bt_3
Then comes this Error Message:
This Steps finished successfully.
HERE YOU CAN LOOK:
bt ~ # fdisk /dev/hdc
Command (m for help): p
Disk /dev/hdc: 4001 MB, 4001292288 bytes
128 heads, 63 sectors/track, 969 cylinders
Units = cylinders of 8064 * 512 = 4128768 bytes Device Boot Start End Blocks Id System
/dev/hdc1 1 969 3906976+ 83 Linux
Command (m for help)
Then i shutdown Backtrack 2
My next Step is, to boot Backtrack 3 from my SD-Card in "BT3 Graphics mode Compiz - Experimental"
Then i opened the Backtrack 3 installer.
# Source = /mnt/live/mnt/sda1/BT3
# Install to = /mnt/hdc1
# Write new MBR (lilo.mbr) to = /dev/hdc
Installation method is "Real" & I activate "Restore Orginal MBR after lilo"
Then I click Install ......
If the Install is complete, i shutdown my Eee.
I eject the SD-Card and start it new.