aireplay-ng ioctl failed on ipw2200
First, yes. I am a total newbie. BUT, I read the wiki for aircrack and the ipw2200. I am stuck.
I am attempting to figure out how aircrack works. I am using an ipw2200 chipset, native to my Dell laptop.
I start airmon-ng using:
airmon-ng start eth0 1
I get a message indicating monitor mode is enabled on eth0
ifconfig indicates frequency 2.412, which should be right. But, when I try:
aireplay-ng --test -i CDC eth0
I get a message:
ioctl(SIOCGIFINDEX) failed: No such device
What device is not being seen? I am simply confused.
PS. I am using BT3 Beta.
aireplay-ng ioctl failed on ipw2200 [setup interface]
First, you will need to learn more about these tools because driver ipw2200 only supports arpreplay,chopchop and interactive attacks only.
The ipw2200 is powerful, but it is not ready out of the box.
Setup an interface that will serve as your monitoring interface:
modprobe ipw2200 rtap_iface=1
ifconfig rtap0 up
I found wifislax works smoothly for a chopchop w/o clients using ipw2200
DON'T STOP READING...AND DEVELOP PATIENCE....