Broadcom BCM4306 not finding ap's
I have a broadcom bcm4306 and it is not finding ap's, even when I have a windows install and it see them fine.I had an install working with it, but don't remember how I got it.
Ifconfig looks like:
(I'm connected through ppp0)
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:130 errors:0 dropped:0 overruns:0 frame:0
TX packets:130 errors:0 dropped:0 overruns:0 carrier:0
RX bytes:6648 (6.6 KB) TX bytes:6648 (6.6 KB)
ppp0 Link encap:Point-to-Point Protocol
inet addr:184.108.40.206 P-t-P:220.127.116.11 Mask:255.255.255.255
UP POINTOPOINT RUNNING NOARP MULTICAST MTU:1500 Metric:1
RX packets:10000 errors:13 dropped:0 overruns:0 frame:0
TX packets:8583 errors:0 dropped:0 overruns:0 carrier:0
RX bytes:9510203 (9.5 MB) TX bytes:1119566 (1.1 MB)
wlan0 Link encap:Ethernet HWaddr 00:90:4b:2c:a6:4d
UP BROADCAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)
And iwconfig looks like
When I put it into monitor mode with airmon-ng, it creates mon0. I use that with airodump-ng, and it starts up fine. But never finds any networks. I tried using the guide in the how-to's demonstrating how to use jockey-gtk to make it work, and it says all is good.
lo no wireless extensions.
wlan0 IEEE 802.11bg ESSID:off/any
Mode:Managed Access Point: Not-Associated Tx-Power=20 dBm
Retry long limit:7 RTS thr:off Fragment thr:off
ppp0 no wireless extensions.
Re: Broadcom BCM4306 not finding ap's
Never mind, I figured it out. My onboard lan (rj-45 jack) had been disabled because I never used it. I wondered if they were connected somehow, because when I opened my laptop there were a couple of cords spawning from the wireless card. One led to the rj-45 jack. So I don't know exactly how it works, but it does.