BT 2.0 Final Problem With Netgear WG511
i used bt20061013 beta before and my card was recognized properly. monitor mode and injection did work.
Now i downloaded 2.0 final and my card isnt even recognized.
I also have a bcm4318 chipset in my notebook which is recognized.
Might this in any way make problems ?
How can i get my WG511 to be recognized again ? i'd prefer to use this one for injecting
any help appreciated
To succesfuly monitor mode
Ok listen carefuly.... to put a wg511t into monitor mode you first have to do the following.
airmon-ng start wifi0
after you did that you will have another interface that is started allowing you to use it as monitor mode. to test it try running this.
airodump-ng -ivs ath0
this should tell you if ath0 is in monitor mode or not.... if ath0 doesnt work then try ath1..... if you want to see if its successfuly in monitor mode issue this command in a shell.
that should tell you all the interfaces that are present.... and one should say monitor mode.
anymore questions just ask :P