AR9285 wifi card just connects on boot proccess
Hi everyone, i have a problem with my wireless card.
I cant get an ip by using dhclient, but this only happens when i am alredy logged in.
If i put the following in /etc/rc.local it works.
It is extrange because when i am alredy logged in, it says there were no DHCPOFFERS. But when those commands are executed on the bootprocess, dhclient gives me an ip.
iwconfig wlan0 essid "cuore"
iwconfig wlan0 key 2323232323
ifconfig wlan0 up
I can do pretty much everything when im logged in (scan networks, inject traffic, monitor mode, etc). The only thing that doesnt work when logged in, is actually making the connection.
I have even tried to put the ip manually but it also doesnt work.
The card is alredy connect because of the /etc/rc.local instructions.
root@haxple-laptop:~# uname -a
Linux haxple-laptop 184.108.40.206 #1 SMP Thu Jun 18 10:57:32 EDT 2009 i686 GNU/Linux
root@haxple-laptop:~# lspci | grep Atheros
01:00.0 Network controller: Atheros Communications Inc. AR9285 Wireless Network Adapter (PCI-Express) (rev 01)
wlan0 IEEE 802.11bgn ESSID:"cuore"
Mode:Managed Frequency:2.437 GHz Access Point: 00:14:95:DB:E9:31
Bit Rate=18 Mb/s Tx-Power=27 dBm
Retry min limit:7 RTS thr:off Fragment thr=2352 B
Encryption key:2323-2323-23 Security mode:open
Link Quality=100/100 Signal level:-59 dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
root@haxple-laptop:~# ifconfig wlan0
wlan0 Link encap:Ethernet HWaddr 00:25:d3:d6:84:86
inet addr:192.168.1.132 Bcast:192.168.1.255 Mask:255.255.255.0
inet6 addr: fe80::225:d3ff:fed6:8486/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:19744 errors:0 dropped:0 overruns:0 frame:0
TX packets:9292 errors:0 dropped:0 overruns:0 carrier:0
RX bytes:10621392 (10.6 MB) TX bytes:1721055 (1.7 MB)
Its just i would like to do this without having to restart my computer everytime i decide to use a new network.