Tp-link wn422g with chip zd1211 is not working.
If start airmon-ng start wlan0, I get
wlan0 ZyDAS 1211 zd1211rw - [phy0]SIOCSIFFLAGS: No such device
If airodump-ng wlan0, I get "ioctl(SIOCSIFFLAGS) failed: Connection timed out"
In BT3 is so not working, because is not detectect.
paste your lsusb output along with fcc id.
Bus 001 Device 002: ID 0ace:1215 ZyDAS WLA-54L WiFi
struggling the same on bt4:
dmesg after plugging in:
usb 2-1: USB disconnect, address 4
usb 2-1: new high speed USB device using ehci_hcd and address 5
usb 2-1: configuration #1 chosen from 1 choice
usb 2-1: reset high speed USB device using ehci_hcd and address 5
phy3: Selected rate control algorithm 'pid'
zd1211rw 2-1:1.0: phy3
# iwconfig wlan1
wlan1 IEEE 802.11bg ESSID:""
Mode:Managed Frequency:2.412 GHz Access Point: Not-Associated
Retry min limit:7 RTS thr:off Fragment thr=2352 B
Link Quality:0 Signal level:0 Noise level:0
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
after the ifconfig, dmesg states:
# ifconfig wlan1 up
SIOCSIFFLAGS: No such device
tried, patching, grabbing firmware, searched thoroughly through these forums, but failed. it just may be that the TP-LINK WN422g is a no go :(
usb 2-1: firmware: requesting zd1211/zd1211b_ub
usb 2-1: firmware: requesting zd1211/zd1211b_uphr
zd1211rw 2-1:1.0: RF MAXIM_NEW_RF 0x8 is not supported
I hear success on ubuntu forums by using the ndiswrapper, but that doesnt support monitor mode does it?
I have since been able to get this card to work with injection, but on ubuntu 9.04
Which is 2.6.28-11-generic
So, I tried this card on ubuntu 8.10, which failed firmware loading when I would ifconfig wlan1 up, which was the same problems I was receiving with BT4.
When I stuffed around with 9.04 for fun, I discovered that the card didnt fail on ifconfig up, and was able to enter monitor mode flawlessly. However injection failed, but that was just a matter of patching the drivers:
So my general understanding is that something in the kernels in 8.10 and bt4 dont like the zd1211rw drivers/firmware.
Hope this aids anyone else with this card
u should patch zd1211rw source code on BT4. zd1211rw driver can't recognise RF uw2453 in wn422g,though driver do support uw2453. here is a patched driver from one chinese wireless bbs,
TL-WN322G+ for bt4-beta Driver(LZM).zip
h t t p://my.xwtop.com/filedown/20090514/0998ff1a.1.zip
aireplay-ng -2 is OK
Follow aircrack tutorial