Arp 0 Ack 0
saygılar sevgiler helpme thank you
image pıcture see
arp 0 ack 0 data 0 :(:(:(:(:(
helpme Thank you
Arkadaşlar komutları düzgün vermeme rağmen ack 0 arp 2 olsada topladığım packet ler işe yaramıyor
saygılar sevgiler goo mornih thank you helpme
Here Goes :-D
From what i see in your photos you are tring to do a WEP crack using Fake Auth to obtain an ARP packet for re-injection.
In your first screenshot i noticed that the AP listed in Airodump that you seem to be targeting has:
PWR = 100
RXQ = 100
Also the Client that seems to be attached has
PWR = "-1"
Rate = "1- 0"
That right of bat says to me that you are too far way from the AP you are trying to attack.
I don't think i need to go any further than that. Figure out the distance you are from the AP and maybe use a better Antenna or move you antenna to a better location.
You want the highest PWR to Lowest RXQ. Also known as the SNR (Signal to Noise Ratio)
Any more questions just let me know.
@ACIDPHYX grateful gratuful thank you helper very much
answer for thank you
words interpreter English understand sorry thank you
Antenna weak singnal %25
to send (someone) one´s regards, say hello to for you goodhearted
I turkey understand englısh
know for you backtrack be successful
I'm dictionary apply
Yes, this is to do with either you not close enough to AP
Personally I don't use these types of cards as they are a nitemare for drivers etc.... esp if this is your 1st time trying to pentest your network, I recommend the never-failed Atheros card..!
However you can get around what you are trying to do, all you need to do is a little research here on this very forum & you will find similar answers to adjusting your power settings etc.
this may get you started